VespaManDan
New member
Hi everyone I am new to the forum but hope to contribute in time with experienc. I have recently sprayed my Vespa in base yellow then put my clear coat on. The finish was not as desired and was a bit to orange peely so I started to sand it back with 2000 grit to flat it and I have only gone and burnt through to the primer. I then thought oh crap I know what I’ll do I’ll sand the rest down with a P 800 and put the base on agian and then clear coat it and there we go job done…. But oh no I put the base on but this time it reacted in parts and went crazed or wrinkly. I don’t know what to do? Any suggestions. I was thinking to sand it lightly then epoxy primer over and start again? Really hoping to get some good advice.
kind Regards
Dan
kind Regards
Dan